TDE-600 room dew point transmitter with LCD for HVAC monitoring, offering analogue or Modbus RTU options, conformal coating and IP30 protection. Select the signal and configured dew point output range to match the connected building automation controller. Confirm the display configuration and available measured values for the supplied version.
Room dew point transmitter with LCD.
Humidity measuring range: 0–100 %RH.
Catalogue dew point output range: −40 to +140 °C (−40 to +284 °F).
Conformal coating for sensing-element protection.
0–10 V, 0–5 V, 4–20 mA or Modbus RTU options.
IP30 protection rating.
| Parameter | TDE-600 |
|---|---|
| Product type | Room Dew Point Transmitter |
| Humidity measuring range | 0–100 %RH |
| Dew point output range | −40 to +140 °C (−40 to +284 °F) |
| Sensing-element protection | Conformal coating |
| Analogue output options | 0–10 V / 0–5 V / 4–20 mA |
| Digital interface option | Modbus RTU |
| Display | LCD |
| Protection rating | IP30 |
The output signals are version options, not simultaneous outputs from every unit. Specify the required interface and configured range. Confirm the LCD display values for the selected version.
The TDE-600 room dew point transmitter provides dew point information for HVAC monitoring and building automation in indoor spaces. A compatible controller can use the information as part of a condensation-monitoring strategy according to the system design. Select a room environment suitable for IP30 protection and confirm performance at the expected operating conditions.
Choose 0–10 V or 0–5 V for a compatible voltage input, or 4–20 mA for a current input. Match the controller’s scaling to the configured dew point output range. For Modbus RTU, obtain the communication settings and register definitions for the supplied unit.
Choose a sensing location representative of the room air being monitored. Consider sunlight, local heat sources and air drafts that may bias the reading. Confirm mounting and connection requirements using the instructions for the supplied version.
TDE-600 is the room model with LCD and IP30 protection. TDE-100 is listed for duct mounting; TDE-200 lists wall or duct mounting. Their housings and installation formats should not be treated as interchangeable.
No stand-alone switching or control output is specified in the catalogue. The transmitter supplies measurement information; control or alarm actions depend on a suitable connected controller and system design.
No. The catalogue labels this as the dew point output range. It does not give dew point accuracy or validated operating conditions for the full span. Provide the expected room conditions and required tolerance for selection.
The listed enclosure rating is IP30. Conformal coating and a 0–100 %RH measuring range do not make the enclosure waterproof or establish tolerance to condensation. Confirm the environment before using it in damp or exposed conditions.
The catalogue lists an LCD, humidity measuring range and dew point output range but does not define all displayed values or channel combinations. Confirm the display and analogue channels or Modbus registers for the selected configuration.
Confirm that the controller supports the selected voltage, current or Modbus RTU interface. Check the configured scaling, supply and load requirements, or communication settings for the supplied version.
MOQ: 5 pcs. Send the room application, expected humidity and temperature conditions, dew point requirement, output, display requirement and quantity to info@heatcoolsmart.com.
For other installation formats, see TDE-100 duct mount and TDE-200 duct / wall mount.





