TDE-100 duct dew point transmitter for HVAC air monitoring, with analogue or Modbus RTU options, conformal coating and an IP65 housing with IP30 probe. Select the signal and configured dew point output range to match your building automation controller. The transmitter is listed for duct mounting.
Duct-mounted dew point transmitter for HVAC air monitoring.
Humidity measuring range: 0–100 %RH.
Catalogue dew point output range: −40 to +140 °C (−40 to +284 °F).
Conformal coating for sensing-element protection.
0–10 V, 0–5 V, 4–20 mA or Modbus RTU options.
Housing IP65 / probe IP30.
| Parameter | TDE-100 |
|---|---|
| Product type | Duct Dew Point Transmitter |
| Humidity measuring range | 0–100 %RH |
| Dew point output range | −40 to +140 °C (−40 to +284 °F) |
| Sensing-element protection | Conformal coating |
| Analogue output options | 0–10 V / 0–5 V / 4–20 mA |
| Digital interface option | Modbus RTU |
| Mounting | Duct mount |
| Protection rating | Housing IP65 / Probe IP30 |
The listed signals are version options, not simultaneous outputs from every unit. Confirm the supplied signal, configured dew point scaling and intended operating conditions before ordering.
The TDE-100 duct dew point transmitter can provide dew point information for HVAC air monitoring and building automation. A compatible controller can use this input as part of a humidity or condensation-monitoring strategy, according to the system design. Confirm suitability for the actual duct environment and required measurement performance.
Choose 0–10 V or 0–5 V for a compatible voltage input, or 4–20 mA for a current input. Match the configured dew point output scaling to the BMS, DDC or PLC. For Modbus RTU, obtain the communication settings and register definitions for the supplied version.
Relative humidity expresses humidity as a percentage at the current air temperature. Dew point expresses the temperature at which that air would reach saturation under the applicable conditions. Specify which value the controller requires rather than treating dew point and %RH as interchangeable signals.
No. The catalogue labels this as the dew point output range and does not specify dew point accuracy or validated operating conditions. Provide the expected operating point and required tolerance so suitability and configured scaling can be confirmed.
Match the controller’s voltage, current or Modbus RTU input. Confirm the signal scaling for analogue versions or register information and communication settings for a digital version. Do not assume that every listed interface is present on the same unit.
The catalogue specifies housing IP65 and probe IP30. Conformal coating and a 0–100 %RH range do not establish that the probe tolerates condensation, water spray or immersion. Confirm the intended environment before selection.
The catalogue identifies TDE-100 as a duct model and does not state a process-pressure rating or compressed-air suitability. Confirm pressure, medium and measurement requirements before considering such an application.
Choose a position representative of the air being monitored and accessible for installation and maintenance. Consider local moisture, temperature gradients and the probe’s protection rating. Follow the mounting instructions supplied with the selected version.
MOQ: 5 pcs. Email info@heatcoolsmart.com with your duct application, expected humidity and temperature conditions, dew point requirements, output type, controller input and quantity.
If your application needs humidity and temperature signals, see THE-100 duct humidity and temperature sensor and transmitter.





