SAE-260 room CO2 transmitter with LCD for HVAC monitoring, with 0–2000 or 0–5000 ppm ranges, analogue or Modbus RTU options and IP30 protection. It measures indoor carbon dioxide concentration for a compatible building automation controller. Specify the range, output and display configuration for your installation.
Room carbon dioxide transmitter with LCD.
CO₂ measuring range options: 0–2000 ppm or 0–5000 ppm.
0–10 V, 0–5 V or 4–20 mA analogue output options.
Modbus RTU digital interface option.
Power supply: 15–35 V DC / 24 V AC.
IP30 protection for suitable indoor installations.
| Parameter | SAE-260 |
|---|---|
| Product type | Room CO₂ Transmitter |
| CO₂ measuring range options | 0–2000 ppm or 0–5000 ppm |
| Analogue output options | 0–10 V / 0–5 V / 4–20 mA |
| Digital interface option | Modbus RTU |
| Power supply | 15–35 V DC / 24 V AC |
| Display | LCD |
| Protection rating | IP30 |
The range and signals are selection options, not simultaneous outputs from every unit. Confirm the ordered range, output, supply requirements and display configuration before installation.
The SAE-260 room CO₂ transmitter provides indoor carbon dioxide information for HVAC and building automation. A compatible controller can use its reading as part of ventilation monitoring or demand-controlled ventilation according to the system design. Select a representative indoor sensing location suitable for IP30 protection.
| Option | Selection guidance |
|---|---|
| 0–2000 ppm | Check that expected room concentrations fit the span and match the controller scaling. |
| 0–5000 ppm | Choose when the application requires the wider listed span; verify accuracy separately for the operating point. |
| 0–10 V / 0–5 V | Match the controller’s voltage input range and ppm scaling. |
| 4–20 mA | Confirm current-input compatibility and the supply, wiring and load requirements for the selected version. |
| Modbus RTU | Confirm RS-485 connectivity and obtain the applicable communication settings and register definitions. |
Select according to the concentration range the application must monitor. A wider span does not by itself establish better accuracy or resolution. Specify the required range and performance when requesting a quotation.
The catalogue lists LCD. The reference ordering information also describes display options. If a plain-front version is needed, request confirmation of that configuration and its availability rather than assuming it is the default.
Choose a location representative of the occupied room air, considering direct exhaled breath, supply-air drafts and nearby openings that could bias the local reading. Follow the installation instructions for the supplied version.
The protection rating is IP30. Confirm the operating environment before selecting it for damp or exposed locations; it should not be assumed waterproof.
The catalogue identifies SAE-260 as a CO₂ transmitter. Do not assume temperature or humidity channels on the standard unit. If additional values are required, specify them and obtain confirmation for the exact model, output and firmware configuration.
Provide the intended concentration range and required tolerance, and request confirmed performance and calibration conditions for the supplied version. The measuring range alone is not an accuracy specification.
MOQ: 5 pcs. Email info@heatcoolsmart.com with the room application, expected CO₂ concentration, measuring range, output, LCD requirement, available power and quantity.
For duct measurement, see SAE-200 duct CO₂ transmitter.





